آخر الأخبار

جاري التحميل ...

Charging a Capacaitor through Resistance



       Consider a capacitor C in series with the resistance R. The capacitor has initially no charge and no voltage across it. When the switch is closed at the instant t = 0, the charge starts accumulating on capacitor and current starts flowing.

       The rate of rise of charge at start is high and later becomes slow and behaves in exponential manner till it reaches equal to the source voltage V. The current at the instant of closing the switch is high and as the voltage across capacitor VC at start is zero this initial current can be expressed as,

       This is maximum charging current. As capacitor starts charging, the capacitor voltage VC increases and finally after a certain period achieves a value equal to V.
Then the charging current reduces to zero. Theoretically, the current becomes zero only after an infinite time. In actual practice the voltage across capacitor and current achieve their steady state values equal to V and zero respectively, in a relatively short time. The variation of charging current and capacitor voltage VC against time is shown in Fig. 2 (a) and (b).

1. Mathematical Analysis
Let                 VC = Voltage across capacitor at any instant.
                       q = Charge on capacitor in coulombs at any instant.
                        i = Charging current at any instant in amperes.
       By kirchhoff's voltage law,

       Integrating both sides of the above equation,

       Where k = Constant of integration.
       At  t= 0, VC = 0, substituting in above,

       When the steady state is achieved, the total charge on the capacitor is Q coulombs.

       Thus capacitor acts as short circuit and in steady state it becomes zero.
2. Time Constant
       The term CR in all the above equation is called the Time Constant of the R-C charging circuit and denoted by Ԏ, measured in seconds.

       So time constant of the R-C series circuit is defined as time required by the capacitor voltage to rise from zero to 0.632 of its final steady value during charging.
Incidentally after t = 2Ԏ, 3Ԏ, 4Ԏ the capacitor voltage attains the values as 0.863 V, 0.95 V, 0.982 V respectively and practically capacitor requires the time 4 to 5 times the time constant to charge fully.

Note : Time constant is the time required for the charging current of the capacitor to fall to 0.368 of its initial maximum value, starting from its maximum value.
3. Initial Rate od Rise of Capacitor Voltage
       The initial rate of rise of capacitor voltage is fast however when the capacitor charges this rate is reduced.

       If the same rate is maintained through out after

       Thus the tangent to the initial part of VC joins VC = V at t = Ԏ as shown in the graph.

       From the above discussion, the time constant of R-C series circuit can be defined as the time in seconds during which the voltage across the capacitor, starting from zero, would reach its final steady value if its rate of change was maintained constant at its initial value throughout the charging period.




about author

hamada i'm hamada rageh electrical power engineer my talent to write articles about electrical engineering and i depend on google books site to write my articles

التعليقات


اتصل بنا

إذا أعجبك محتوى مدونتنا نتمنى البقاء على تواصل دائم ، فقط قم بإدخال بريدك الإلكتروني للإشتراك في بريد المدونة السريع ليصلك جديد المدونة أولاً بأول ، كما يمكنك إرسال رساله بالضغط على الزر المجاور ...

جميع الحقوق محفوظة

your electrical home